If I make a new project, drag two ID vaults on to it, and drag an eDir to eDir
driver in to connect them, the vaults are shown as connected by this driver.

If I make a new project, and import two ID vaults in to it that are connected by
eDir drivers, they don't show their connection to each other.

Is there a way to get Designer to link the eDir driver in Vault 1 to the
corresponding eDir driver in Vault 2?


---------------------------------------------------------------------------
David Gersic dgersic_@_niu.edu

I'm tired of receiving rubbish in my mailbox, so the E-mail address is
munged to foil the junkmail bots. Humans will figure it out on their own.